I have this cisco catalyst 6500 Switch series 9 – slot it has a long history of supervisor fail down and errors so we will replacement by now supervisor .
Are there any steps to flow replacement supervisor and are there any commands to run it before replacement and remover the old one .
{ 5 comments… read them below or add one }
There is still a lot of information needed before anyone can answer your question.
First, what supervisor are you running now? Sup 1a, Sup 2, Sup 32, or Sup 720?
Are you running redundant supervisors?
Are you replacing the current supervisor with the same type, or are you upgrading to a VSS or Sup 720?
Are you running in hybrid mode (Cat-OS and IOS), or are you running in Native (IOS only)?
If you are upgrading from a sup2 or older, you may have to reconfigure your blades to accomidate supervisor 720s (they have to go in slots 5 & 6).
With this information, we can provide more help on your request.
ho are you buchholr
this is some answer you asked for
First, what supervisor are you running now? Sup 1a, Sup 2, Sup 32, or Sup 720?
Cat 6k sup 1 Enhanced QoS WS-X6K-SUP1A-2GE
Are you running redundant supervisors?
no but I have redundant by used another switch
Are you replacing the current supervisor with the same type, or are you upgrading to a VSS or Sup 720?
no by the same current supervisor
Are you running in hybrid mode (Cat-OS and IOS), or are you running in Native (IOS only)?
IOS and used Cat6k MSFC 2 daughterboard WS-F6K-MSFC2 IOS
If you are upgrading from a sup2 or older, you may have to reconfigure your blades to accomidate supervisor 720s (they have to go in slots 5 & 6).
Kindly refer to http://www.cisco.com/en/US/partner/products/hw/switches/ps700/products_tech_note09186a008015504b.shtml and locate the exact problem and share.
hi shailesh.h
the linke does not work
I attached document for your ready reference. I think this might required CCO login to visit this page..
You must log in to post a comment.