I was told in the training sessions that the Administrative Distance for Default Route is 255 and is the least preferred route. My interviewer says its 1. Which is correct?
{ 6 comments }
I have a very simple configureation with PPP over FR, and runing RIP on it. there are two routes about this subnet in routing table like 150.1.1.1/32 and 150.1.1.0/24 both exist in routing table. can i fix this problem?
{ 3 comments }
I have this configuration and we need to tune the “tx-ring-limit” to a smaller value. Whick is the best tx-ring-limit in vbr-nrt 128? Regards, Martin .. interface ATM1/0 no ip address ip route-cache flow scrambling cell-payload framing crc4adm no ima-group atm pvc x xx ilmi atm ilmi-keepalive ! interface ATM1/0.1 point-to-point pvc 1/x vbr-nrt 128 [...]
{ 2 comments }
Hopefully this is a fairly quick question, I would have tested this in a lab, but run out of time. Is it possible to run both HSRP and PBR together without issue? What I have is a remote site that is connected to HQ site by two redundant links. One of these has a greater [...]
{ 2 comments }
I have a default route from my router to other router. ip route 0.0.0.0 0.0.0.0 10.1.1.125 ip route is out of range – [1-223]
{ 3 comments }
I need an IOS that will allow ‘crypto’ commands so I can disable telnet to the router and require SSH connections only. The ‘IP-base’ image does not have the ‘crypto’commands. What IOS level above ‘IP-base’ do I need for this functionality
{ 2 comments }
My computer is connect to the internet via an ISP using modem (ADSL). The IP address of my PC is dynamically assigned by the ISP. Now I want to add three more PCs to the network (LAN) so that all of them can access the internet. 1)Can I do it without using a router or [...]
{ 4 comments }
Stub area is an area that does not accept information about routes external to the autonomous system. Does the “external routes” must be from non-OSPF (RIP, IGRP, EIGRP) always with different AS, or it can be from another OSPF but with different AS ?
{ 4 comments }
I have found this article in net http://www.ciscopress.com/articles/article.asp?p=99982&seqNum=5 “Point-to-multipoint networks are a special configuration of NBMA networks in which networks are treated as a collection of point-to-point links. Routers on these networks do not elect a DR or BDR, and because all links are seen as point-to-point, all OSPF packets are multicast”. My confusion are [...]
{ 3 comments }