How to configure two 6506’s for Redundancy.
I have two 6506s with one “WS-X6K-SUP2-2GE w : 5.1” pre device. I would like to set these two devices in a redundancy topology, meaning if the primary 6506 failed the secondary (standby) 6506 will take total identity of the failed 6506, including moving all the running configuration information.
Can someone please tell me the best way to make this happen and/or point me in the right direction so that I can research?
SHOW MOD IS THE SAME ON BOTH DEVICES:
WS-C6506 Software, Version NmpSW: 8.2(2)
Copyright (c) 1995-2004 by Cisco Systems
NMP S/W compiled on Apr 7 2004, 12:09:03
System Bootstrap Version: 7.1(1)
System Web Interface Version: Engine Version: 5.3.4 ADP Device: Cat6000 ADP Version: 5.0 ADK: 40
System Boot Image File is ‘bootflash:cat6000-sup2cvk9.8-2-2.bin’
System Configuration register is 0×2102
Hardware Version: 3.0 Model: WS-C6506 Serial #: SAL08332DYP
PS1 Module: WS-CAC-1300W Serial #: ABC08232025
PS2 Module: WS-CAC-1300W Serial #: ABC08232027
Mod Port Model Serial # Versions
— —- ——————- ———– ————————————–
1 2 WS-X6K-SUP2-2GE SAL083742B0 Hw : 5.1
Fw : 7.1(1)
Fw1: 6.1(3)
Sw : 8.2(2)
Sw1: 8.2(2)
WS-F6K-PFC2 SAL08373W54 Hw : 3.5
Sw :
WS-X6K-SUP2-2GE SAL083742B0 Hw : 5.1
Sw :
2 16 WS-X6516A-GBIC SAL08342XAE Hw : 4.1
Fw : 7.2(1)
Sw : 8.2(2)
3 48 WS-X6148-45AF SAL08186FS3 Hw : 1.0
Fw : 5.4(2)
Sw : 8.2(2)
WS-F6K-FE48-AF SAD08250552 Hw : 1.2
Sw : 8.2(226)
4 48 WS-X6548-GE-TX SAL1126SAPN Hw : 11.1
Fw : 7.2(1)
Sw : 8.2(2)
15 1 WS-F6K-MSFC2 SAL08342LA6 Hw : 2.8
Fw : 12.1(22)E2
Sw : 12.1(22)E2
DRAM FLASH NVRAM
Module Total Used Free Total Used Free Total Used Free
—— ——- ——- ——- ——- ——- ——- —– —– —–
1 262144K 82831K 179313K 32768K 14484K 18284K 512K 306K 206K
{ 1 comment… read it below or add one }
Hello,If you had 6500-E, you could pair them together and create a VSS bundle similar to 3750 stacking, but unfortunately you have none E 6500, so that is not poosible.
You also have to have the right sup to do VSS.(Sup-720-VS)
You must log in to post a comment.